Installation Manual
Calibration and Adjustment 6-1
6 Calibration and Adjustment
Overview
Your Axiom X-1000 Series Dispensing System is calibrated and adjusted at the factory prior to shipping.
However, if any components have been changed or moved, it may be necessary to recalibrate or readjust
some components. This section contains the following calibration and adjustment procedures:
• Camera Focus Adjustment and Calibration
• Scale Leveling and Calibration
• Dispensing Calibration Module Leveling and Height Adjustment
• Board Sensor Sensitivity Adjustment
• Lift Table/Clamp Bar Airflow Adjustment
• Impingement Heater Airflow Adjustment
• Linear Encoder Gap Adjustment
• Heater Calibration
• Fluid Air Pressure Gauge Configuration
• Dispensing Head Counterbalance Adjustment
? NOTE Refer to the Axiom X-1000 Operations Manual and/or the FmNT User’s Guide for setup
instructions for the following dispensing system components:
• Vision System • Height Sensor
• Needle Sensor • Needle Heater
• Low Fluid Sensor • Heater Tooling
CAUTION! The procedures in this section should only be performed by a trained
service technician.
Record Keeping
The type of calibration or adjustment performed should be recorded in maintenance records for the
dispensing system along with names of technicians and other pertinent data.