Installation Manual

Power-up and Testing 5-49
j. In the Production Window, click on the Run button and then double click on Single Dry
Run
in the area below the Run Production button. See Figure 5-26.
> The Run Window will open.
k. On the Run Status tab, verify the program filename is the one desired, the
Dry radio
button is selected, and the
Use Conveyor box is checked.
l. To start the program click on
Go.
> A “Clear the conveyor” message appears. Make sure there are no boards or boats on
the Conveyor Belt.
> A “Waiting for a board” message appears.
m. Place a simulated production workpiece at the upstream end of the Conveyor.
n. Press the Number
3 TS-01 button to move the workpiece to the dispense station.
> Dispensing is performed.
> When dispensing is complete, the red Number 4 LED on the TS-01 illuminates.
o. Press the Number
5 TS-01 button.
> The red Number 2 LED on the TS-01 illuminates.
> The workpiece will either stop at the post-dispense station if there is one, or exit the
system entirely if there is not.
CAUTION! Prevent workpieces from falling after exiting the dispensing system or they will be
damaged.
Figure 5-26 Program Run Window
A
sy
m
te
k FmNT Pr
oduct
i
o
n Win
dow
A
sy
m
te
k FmNT R
u
n Win
dow