Installation Manual

Power-up and Testing 5-43
10. View the image in the video display.
> The reticles should not be visible.
> If the image is focused, the Camera does not need to be adjusted.
> If the image is not focused, the Camera focus must be adjusted in accordance with the
procedure in the Calibration and Adjustment section of this manual.
11. If your system has DOAL, verify the bottom of the lighting module is approximately
1.1 inches (27.9 mm) above the workpiece surface to be viewed with a metal ruler.
> If the lighting is not at the correct height, grasp the light with your hand and loosen the
adjustment screw. See Figure 5-22. Then slide the light up or down on its bracket until it
is at the proper distance and retighten the adjustment screw.
12. Perform Camera calibration in accordance with the procedure in the Calibration and
Adjustment section of this manual.
Item Description
1 Camera
2 Lighting Module Height Adjustment Screw
Figure 5-22 Vision System Lighting Height Adjustment
1
2