Owner manual

Operation 4-5
4. If a message to run a Valve Offsets routine appears, click on OK.
 A message should appear that indicates the dispensing system is being initialized.
5. When the Fluidmove Message 30416 - Dispenser Motor References Not Found (Figure 4-2)
appears, click
OK to Home the Dispenser.
 The Fluidmove Main Window (Figure 4-3) will open.
6. Check to make sure the dispensing head is in the proper Home position.
 NOTE To start a production run, refer to 4.8 Running Production.
Figure 4-2 Fluidmove Message 30416
Figure 4-3 Fluidmove Main Window (FmXP shown)