Owner manual

Specifications 7-7
Table 7-3 Dispensing Valve-Related Specifications
Characteristic Specification
Recommended
Dispensing Valves
(2)
• DJ-9000 DispenseJet
®
• DP-3000 Linear Positive Displacement Pump
• DV-8000 Heli-Flo
®
Pump
Single Dispense Valve
(X-Y)
(3)
• DV & DJ:
(4)
457.2 x 457.2 mm (18.0 x 18.0 in.)
• DP:
442 x 418 mm (17.4 x 16.4 in.)
Dual Dispense Valves
(X-Y)
(3)
(Valve 1
/
Valve 2)
• DV or DJ/DV or DJ:
(4)
357.1 x 431.4 mm (14.0 x 17.0 in.)
• DV or DJ /DP:
(4)
353 x 394 mm (13.9 x 15.5 in.)
• DP/DP:
303 x 387 mm (12.6 x 15.5 in.)
Notes: 1. Dispense area dimensions based on the standard o-ring conveyor and valve options.
Includes mounted camera and height sensor (tactile or laser).
(2) Refer to the applicable dispensing valve manual for specifications.
(3) X = the direction of conveyor motion.
Y = measured from the front conveyor rail to the back wall of the dispensing chamber.
(4) DJ refers to the DJ-9000. Contact Asymtek for DJ-2000 specification.
Table 7-4 Scale Specifications (X-1020)
Characteristic Specification
Weighing Capacity 100 grams maximum
Scale resolution 0.1 mg
Repeatability 0.1 mg
Linearity 0.2 mg
Accuracy Depends on dispensing valve selected
Stabilization Time < 5 seconds
Calibration External with weights
Interface RS-232 bi-directional with serial command
Cable/Connector 9 pin D-sub with standard RS232 pin-out for a straight
through connection; length: 11 ± 0 .50 in.
Power Regulated 12 VDC @ 800mA
Environmental
• Temperature 15–40 °C (59–104°F)
• Humidity less than 95% R.H.