Owner manual

Maintenance 6-11

6. While holding the probe in place, tighten the setscrew just until the probe is held firmly in

place. Remove the hex key and rotate the probe to its former position.

7. Perform adjustments of the probe as specified in 3.7.3 Probe Adjustments to precisely align

the probe bend with the needle tip and adjust the probe-to-needle distance.

8. After the probe position has been adjusted, close the hatch and press the

ON (l) button on the

operator’s console.

9. Perform a Valve Offsets routine in Fluidmove. Refer to the applicable Fluidmove User Guide

or Online Help for assistance.

Item Description

1 Probe Bushing

2 Height Sensor Probe

3 Probe Block

4 Probe Setscrew Access Hole (on side of Height Sensor)

Figure 6-4 Height Sensor Probe Installation