Owner manual

4-28 Operation
4.7 Operating Heater Tooling
CAUTION! The operator can turn the heaters ON and OFF and monitor their function.
However, only authorized personnel should set heater parameters.
 NOTE Contact your applications engineer or Asymtek Technical Support for information about
setting heater parameters for your particular application.
Operate heater tooling as follows:
WARNING! The heater may be hot. Avoid touching heater surfaces or burn injury may occur.
1. In the Fluidmove Main Window, click on Run a Program .
2. In the Production Window (Figure 4-15), click on
Setup and in the list box select Setup
Heater 2
.
Figure 4-15 Fluidmove Production Window