Owner manual

4-24 Operation
4.6 Operating Fluid Heaters
4.6.1 Needle Heater Operation
CAUTION! The operator can turn the heaters ON and OFF and monitor their function.
However, only a trained service technician should set heater parameters.
 NOTE Contact your applications engineer or Asymtek Technical Support for information about
setting heater/cooler parameters for your particular application.
Operate the needle heater as follows:
WARNING! The heater may be hot. Avoid touching heater surfaces or burn injury may occur.
1. In the Fluidmove Main Window, click on Run a Program .
2. In the Production Window (Figure 4-11), click on
Setup and in the list box select Setup
Heater 1
.
Figure 4-11 Fluidmove Production Window