Quick Operations Owner's manual

4-12 Operation
Fluid Air Pressure Regulator and Gauge
The Fluid Air Pressure Regulator and Gauge set (Figure 4-7) consists of a precision Regulator and a digital
gauge. This set precisely controls the air pressure going to the receiver head of the fluid syringe or reservoir.
The system maintains a steady flow of dispensing fluid to the Dispensing Valve by applying air at a constant
pressure to the syringe or reservoir while the dispensing system is operating.
The level of air pressure supplied to the syringe or reservoir depends on the type of fluid and the Dispensing
Valve being used in the dispensing process. Refer to the Installation and Operation Manual applicable to the
Dispensing Valve installed on your dispensing system for recommended pressure settings.
Your X-1000 Series Dispensing System has two independent Fluid Air Pressure Regulator and Gauge sets
to support a Dual-Action Dispensing Head option.
Cooler Air Pressure Regulator and Gauge
The Cooler Air Regulator and Gauge set (Figure 4-7) controls air pressure for the Thermal Control Assembly
on a DJ-9000 Series Dispensing Valve. Refer to Table 4-5 for the recommended pressure setting.
To adjust Fluid and Cooler Air Pressure Regulators:
1. Verify that the dispensing system is ON.
! The Light Beacon will display a green or solid yellow light.
2. Open the lower front cabinet door and find the regulator to be adjusted. See Figure 4-7.
3. While watching the appropriate gauge, rotate the adjustment knob:
! Clockwise to increase pressure.
! Counterclockwise to decrease pressure.
" NOTE When decreasing pressure, lower the pressure past the target level, then rotate the
adjustment knob clockwise (right) to raise pressure to the desired setting. This will
help prevent false readings.
Tooling Air Pressure Regulator and Gauge
The Tooling Regulator and Gauge set (Figure 4-7) controls air pressure for Stop Pins and Lift Tables/Clamp
Bars. Refer to Table 4-5 for the recommended pressure setting for tooling air.
Valve Air Pressure Regulator and Gauge
The Valve Air Pressure Regulator and Gauge set (Figure 4-7) controls the air pressure that actuates some
Dispensing Valves (DJ-2000, DP-3000) during dispensing. For details on how air is used for Dispensing
Valve operation, refer to the manual applicable to the Valve installed on your dispensing system.
In dispensing systems with a Dual-Action Dispensing Head, the Valve Air Pressure Regulator and Gauge set
can supply both Dispensing Valves with air pressure.
Consult the manual applicable to the Valve installed on your dispensing system for the recommended
pressure setting for your Dispensing Valve.
+
–