Manual

3-80 Detailed Descriptions of ACL Commands
ZM [<count>,<new>[,<which>]] Z-axis Multiple Mid-move Digital Outputs
This command will perform the same action as the MD command only it is applied to the Z
axis. This feature allows the dot dispense cycle to occur during the Z axis decent to a
dispense point which speeds up the dispense operation.
The parameters syntax is the same as the MM command.
* Dispense Dot
This is a single character command which will perform the equivalent of the following series
of ACL commands to speed up the dispensing for dots:
VM0:MR0,0;VM15;
At 19,200 baud this command could save 7 MS per dot. At 9,600 baud it could save 14 MS
per dot. The asterisk was chosen because it looks something like a dot to help you remember
it.
The PD and MD commands must have been previously executed and the * command must
be the first character of a new command.