Smoke Control Kit Instructions

5
These instructions cover the fitting of the
Smoke Control Kit
1. Parts List
Appliance Smoke control kit Part No.
Uno 1 NP-UNOSZKIT
Uno 2 NP-UNOSZKIT
Uno 4 NP-UNOSZKIT
Kit contents:
1 x Smoke Control Bracket
2. Smoke Control Kit - Fitting Instructions
Tools required:
8mm Spanner
Crosshead Screwdriver. (Uno 2 & 4 only)
To make this appliance exempt from the controls that
govern smoke control areas the air vent control must be
modified.
Uno 1
Fully open the air vent control by moving the slider to the
back.
Open the main door.
Remove the 2 bolts and washers.
Fit the Smoke Control bracket and secure with the
washers and bolts previously removed.
Smoke Control
Bracket
Check that door catch closes correctly. Adjustment can
be achieved by tightening or loosening the bolts securing
the Smoke Control bracket.
Close the door.
Uno 2 & 4
Fully open the air vent control by moving the slider to the
back.
Follow the relevant section for your appliance.
Uno 2 only
Open the main door.
Pull the top of the lower panel forward to release the
catches.
Lift the lower panel off the bottom studs to remove.
When refitting ensure that the bottom holes locate over
the studs at the base of the appliance.