Installation & User Instructions

10 GB
2. Technical information
The stoves from Nordpeis all have secondary
combustion and are clean burning. The combustion
takes place in two phases: rst the wood burns and
then the gases from the fumes are lit by the hot air.
This ensures that these new stoves have minimal
emissions of soot particles and un-burnt gases (such
as CO) and are thus better for the environment. Clean
burning stoves require a small amount of wood in order
to obtain a good heat output. Use exclusively clean and
dry wood. We recommend seasoned hardwood with a
maximum moisture content of 20%.
Material Sheet steel
Surface treatment Heat resistant paint
Weight (kg)
Uno 1 84
Uno 2 92
Uno 4 88
Draught system Air vent control with
start up air setting
Combustion system Secondary combustion
(Clean burn system)
Combustion air
consumption (m³/h)
8
Operating range, Clean
burn (kW)
3,9 - 6
Heating area (m2) 55 - 90
Maximum fuel length (cm) 30
Flue outlet Top and rear
Flue (Ø mm) Outer* 150
*Alternative versions exsists
due to National require-
ments
Flue gas temperature at
ue connector (°C)
320
Draft at ue connector
recommended (Pa)
15 - 25
Data according to
EN 13 240
Nominal heat output (kW) 4
Efciency (%) 81,8
CO @ 13% O
2 (%) 0,07
Flue gas temperature (°C) 262
Draft (Pa) 12
Fuel recommended Wood logs
Fuel length recomended
(cm)
25
Fuel charge (kg) 0,78
Refueling interval (min-
utes)
45
Opening of the air vent
control (%)
33
Operation Intermittent*
* Intermittent combustion refers to normal use of a replace, i.e. new
wood is inserted when the previous load has burned down to ember
3. Distance to combustible material
Ensure that the safety distances are respected
(FIG 1).
When connecting a steel chimney to the top outlet use
the security distances required from the manufacturer.
4. Assembly
The following tools are necessary:
• 5 mm Allen key (included)
• 10/17 mm wrench (included)
• Screwdriver
Releasing the stove from the pallet:
Uno 1: Remove the screws holding the back cover
on the pedestal.Remove the back cover to acess det
screws holding the stove to the pallet. Remove the
screws using a 10mm wrench. Put the back cover back
in place and fasten the screw holding it.
Uno 2: The stove is xed to the pallet both front and
rear. Use a 10mm wrench to remove the transport locks
tted through the back plate of the product. To acess
the screws in front, the panel under the door must be
removed. Open the door and pull the lower panel
carefully outwards and up. Loosen the screws and push
the product forward to release it from the pallet.
Uno 4: Open the door under the combustion chamber.
Remove the tting covering the leg adjustment and the
four screws holding the product to the pallet.
Operating control
When the stove is in an upright position, and prior
to connecting it, control that all functions are easy to
manoeuvre and appear satisfactory.
Door (FIG 2)
Handle is pulled out
Handle is pushed in
Open
Close
Air vent (FIG 2)
Forward
Backward
Closed
Open