Instruction Manual

8 GB
1. Prior to assembling the stove
All our products are tested according to the latest
European requirements and also to the Norwegian
SINTEF standard, which includes particle tests.
Several European countries however have individual
rules for installation of inserts, stoves and replaces.
The client is entirely responsible for the fullling of
these local rules concerning the installation in his
region/country. Nordpeis (Northstar) is not responsible
regarding correct installation. You should check local
regulations concerning: distance from rebox to
combustible/ammable materials, insulation materials/
requirements between stove and back wall, size
of oor plates in front of stove if required, uepipe
connection between stove and chimney and insulation
requirements if uepipe goes through inammable
wall such as a wooden wall.
Chimney Draught
Compared with older models, the clean burning stoves
of today put signicantly higher demands on the
chimney. Even the best stove will not work properly
if the chimney does not have the right dimensions or
is not in good working order. The draught is mainly
controlled by gas temperature, outside temperature,
air supply as well as the height and inner diameter
of the chimney. The diameter of the chimney should
never be less than that of the ue/chimney collar. At
nominal e󰀨ect there should be a negative pressure of
14 to 25 Pascal.
The draught increases when:
• The chimney becomes warmer than the outside air
• The active length of the chimney is increased (over
the hearth)
• Good air supply to the combustion
It can be di󰀩cult to obtain the right draught conditions
in case the chimney is too large relative to the
replace, as the chimney does not heat up well
enough. If possible, insert a smaller chimney
pipe. Draught that is too strong can also be
controlled with a damper. If necessary, contact a
chimney sweeper.
For your own safety, comply with the assembly
instructions. All safety distances are minimum
distances. Installation of the insert must comply
with the rules and regulations of the country where
installed. Nordpeis AS is not responsible for wrongly
assembled inserts.
The illustration indicates the approximate center height
of the hole for the ue. Distortions in oors and walls
may inuence the height. Place the stove for accurate
position and height of the ue/chimney connection.
We accept no liability for typographical errors and
changes.
1. Prior to assembling the stove 8
Chimney Draught 8
2. Technical Information 9
3. Distance to combustible material 9
4. Assembly 9
Connection of the ue 9
Operating control 9
5. Lighting the re for the rst time 9
6. Maintenance 10
Cleaning and inspection 10
Ashes 10
Thermotte® Plates 10
Door and glass 10
7. Warranty 11
8. Advice on lighting a re 11
Some advice in case of combustion problems 12
INDEX
IMPORTANT SAFETY PRECAUTIONS!
1. Please follow the installation manual when
connecting your stove / replace to the chimney /
ue pipe. If connected di󰀨erently from instruction
please, consider the heat radiation from the ue
pipe to the surrounding materials.
2. Before use, please carefully read the user manual
and follow the instructions.
3. Integrated or dened convection openings may
never be reduced or partially obstructed. This may
lead to overheating, which again can cause house
re or serious damage to the product.
4. Use only designated re starters. Never use
gasoline, diesel or other liquids to start the re.
This may cause explosions!
5. Never use other fuel than natural dry chopped
wood. Briquettes, peat, coke, coal and waste
from construction materials develops far higher
temperatures and emissions than natural wood.
Since your product has been designed for use
with natural wood only, other fuels may damage
the product, chimney and surrounding
constructions.
6. In case of damage to glass or door gasket, all use
of the product must be discontinued until the
damage has been repaired.
Failure to follow these precautions will leave your
warranty void and expose people and property to
danger.
Advise: Even if not required in your area, it is always
wise to have a qualied stove / replace tter do the
installation, or at least the nal inspection before use.