Operation Manual
Adjustment of the wringing cycle
To carry out the adjustment of wringing cycle:
• Move on the symbol located on the electronic
instrument by using Mode key.
• Maximum wringing cycle of the programme that you have selected will be
displayed on the time indicator.
• You can reduce wringing cycle up to the wringing cycle you request by
using select key. These levels will appear on the time indicator.
• If you want to cancel the wringing operation,
press on the select key until “ NO SPIN” signal is
displayed on the time indicator. When “ NO
SPIN” signal appears, the symbol will be
displayed on the electronic instrument.
• If you have skipped the wringing cycle level that you have requested, you
can again adjust the wringing cycle by pushing on the select key
repeatedly. If you have selected a different wringing cycle from the
maximum wringing cycle, the symbol on the electronic instrument will
remain lighted up to the completion of the programme.
Wringing cycles are illustrated in the table-2. If the adjustment of the wringing
cycle is not carried out, wringing operation will be performed at a maximum
wringing cycle depended on the programme feature.
Regolazione del ciclo di strizzatura
Per regolare il ciclo di strizzatura:
• Posizionarsi sul simbolo sullo strumento
elettronico usando il tasto modalità.
• Il massimo ciclo di strizzatura del programma
selezionato verrà visualizzato sull’indicatore
dell’ora.
• È possibile ridurre il ciclo di strizzatura a quello richiesta usando il tasto di
selezione. Questi livelli compaiono sull’indicatore dell’ora.
• Se si vuole annullare la strizzatura premere il tasto di selezione fino a che
sull’indicatore dell’ora verrà visualizzato “ NO SPIN” ” (nessuna
centrifuga) Quando compare ”NO SPIN”, il simbolo verrà visualizzato
sullo strumento elettronico.
• Se il ciclo di strizzatura richiesto è stato saltato, è possibile regolarlo di
nuovo spingendo ripetutamente il tasto di selezione. Se è stata
selezionata ciclo di strizzatura diverso da quello massimo, il simbolo
resta acceso sullo strumento elettronico fino al completamento del
programma.
I cicli di strizzatura sono indicati nella tabella 2. Se la regolazione del ciclo di strizzatura non è
fatta, la strizzatura sarà al ciclo massimo a seconda delle caratteristiche del programma.