Datasheet

Page 80 of 161
nRF8001 Product Specification
Revision 1.2
nRF8001 mode dependencies are illustrated in the state machine chart in Figure 45.
Figure 45. State Machine: Transition between operational modes
3
Each mode has an associated set of ACI commands and events. An overview of the ACI commands and
events applicable to the operational modes is listed in Table 29 on page 87
.
3. The state diagram illustrates the normal mode transitions for nRF8001. Note that all possible transitions are not
depicted in the figure. For example; it is possible to enter Setup mode from Test mode. See section 23.1 on page 91
and
the protocol reference description of the ACI commands
Setup, Sleep and Test for details.
RESET
Unknown
Standby
Setup
Test
Test(Exit)/
Setup in non
volatile memory
Test(Enter)
Setup()
CommandResponseEvent(Success)
Sleep
Wakeup
Sleep
Setup()
nRF8001 will enter Exit to Standby mode
after completing the full Setup cycle or if
the setup data has been stored in NVM
(lock).
Connect/
Bond
Disconnect/
DisconnectedEvent
Active
(Connection)
see separate
diagram
Active
ReadDynamicData /
WriteDynamicData
Test(Exit)/
Setup in
volatile memory
Test(Enter)