User's Guide
Table Of Contents
- Contents
- Revision history
- Introduction
- Kit content
- Getting started
- Firmware
- Firmware update
- Hardware description
- Regulatory notices
- Glossary
- DK (Development Kit)
- GPIO
- Global Positioning System (GPS)
- Integrated Development Environment (IDE)
- MCUboot
- Near Field Communication (NFC)
- Personal Unblocking Key (PUK)
- Software Development Kit (SDK)
- SEGGER Embedded Studio (SES)
- Subscriber Identity Module (SIM)
- System in Package (SiP)
- System on Chip (SoC)
- User Equipment (UE)
- Universal Integrated Circuit Card (UICC)
- Universal Serial Bus (USB)
- Acronyms and abbreviations
- Legal notices
3
Getting started
Setting up Nordic Thingy:91 requires completing the following steps.
Before you start:
• Unpack Nordic Thingy:91.
• Make sure to update the Nordic Thingy:91 firmware as explained in the section Firmware update on
page 15.
• Make sure you have an nRF Connect for Cloud account and sign in to nRF Connect for Cloud.
Once you are signed in, perform the following steps.
1. Add new LTE device.
Figure 2: Adding new LTE device in nRF Cloud
2. Verify and activate the SIM card.
Input SIM ICCID and Personal Unblocking Key (PUK) from the SIM card, and add personal information.
Figure 3: Placement of PUK and SIM ICCID on the SIM card
3. Gently remove the rubber overlay to reveal the power switch and the top of Nordic Thingy:91. Insert
the SIM card.
4418_1336 v1.2
9