User's Guide
Table Of Contents
- Contents
- Revision history
- Introduction
- Kit content
- Getting started
- Firmware
- Firmware update
- Hardware description
- Regulatory notices
- Glossary
- DK (Development Kit)
- GPIO
- Global Positioning System (GPS)
- Integrated Development Environment (IDE)
- MCUboot
- Near Field Communication (NFC)
- Personal Unblocking Key (PUK)
- Software Development Kit (SDK)
- SEGGER Embedded Studio (SES)
- Subscriber Identity Module (SIM)
- System in Package (SiP)
- System on Chip (SoC)
- User Equipment (UE)
- Universal Integrated Circuit Card (UICC)
- Universal Serial Bus (USB)
- Acronyms and abbreviations
- Legal notices
7
Regulatory notices
The following regulatory notices apply to Nordic Thingy:91.
7.1 FCC regulatory notices
Modification statement
Nordic Semiconductor ASA has not approved any changes or modifications to this device by the user. Any
changes or modifications could void the user’s authority to operate the equipment.
Interference statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Wireless notice
This device complies with FCC radiation exposure limits set forth for an uncontrolled environment and
meets the FCC radio frequency (RF) Exposure Guidelines. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter. The antenna should be installed and
operated with minimum distance of 20 cm between the radiator and your body.
FCC Class B digital device notice
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
4418_1336 v1.2
42