User's Guide
Table Of Contents
- Contents
- Revision history
- Introduction
- Kit content
- Getting started
- Firmware
- Firmware update
- Hardware description
- Regulatory notices
- Glossary
- DK (Development Kit)
- GPIO
- Global Positioning System (GPS)
- Integrated Development Environment (IDE)
- MCUboot
- Near Field Communication (NFC)
- Personal Unblocking Key (PUK)
- Software Development Kit (SDK)
- SEGGER Embedded Studio (SES)
- Subscriber Identity Module (SIM)
- System in Package (SiP)
- System on Chip (SoC)
- User Equipment (UE)
- Universal Integrated Circuit Card (UICC)
- Universal Serial Bus (USB)
- Acronyms and abbreviations
- Legal notices
Hardware description
Figure 32: Measuring current to the nRF9160
Figure 33: Measuring current to the nRF52840
Figure 34: Current measurement schematic
6.11 Programming and debugging interface
Nordic Thingy:91 is equipped with one programming and debugging interface connector (P8) that is
shared between the nRF9160 and nRF52840.
4418_1336 v1.2
36