User's Guide
Table Of Contents
- Contents
- Revision history
- Introduction
- Kit content
- Getting started
- Firmware
- Firmware update
- Hardware description
- Regulatory notices
- Glossary
- DK (Development Kit)
- GPIO
- Global Positioning System (GPS)
- Integrated Development Environment (IDE)
- MCUboot
- Near Field Communication (NFC)
- Personal Unblocking Key (PUK)
- Software Development Kit (SDK)
- SEGGER Embedded Studio (SES)
- Subscriber Identity Module (SIM)
- System in Package (SiP)
- System on Chip (SoC)
- User Equipment (UE)
- Universal Integrated Circuit Card (UICC)
- Universal Serial Bus (USB)
- Acronyms and abbreviations
- Legal notices
Firmware update
6. Click Browse from the drop-down list that appears as a result of the previous step in the nRF Connect
Programmer as shown in the following figure.
Figure 10: Selecting the firmware image file using Add
HEX file (Browse) option in the nRF Connect Programmer
7. Select the MCUboot compatible HEX file from the file browser that opens up.
8. Click Write on the Device pane in the right as shown in the following figure.
4418_1336 v1.2
18