User's Guide
Table Of Contents
- Contents
- Revision history
- Introduction
- Kit content
- Getting started
- Firmware
- Firmware update
- Hardware description
- Regulatory notices
- Glossary
- DK (Development Kit)
- GPIO
- Global Positioning System (GPS)
- Integrated Development Environment (IDE)
- MCUboot
- Near Field Communication (NFC)
- Personal Unblocking Key (PUK)
- Software Development Kit (SDK)
- SEGGER Embedded Studio (SES)
- Subscriber Identity Module (SIM)
- System in Package (SiP)
- System on Chip (SoC)
- User Equipment (UE)
- Universal Integrated Circuit Card (UICC)
- Universal Serial Bus (USB)
- Acronyms and abbreviations
- Legal notices
Getting started
Figure 4: Inserting the SIM card
4. Once the SIM card is inserted, power on Nordic Thingy:91. You will find the power switch next to the
micro-USB port.
Figure 5: Nordic Thingy:91 Power switch
Wait for yellow breathing in the indicator LED. If the LED does not turn yellow, check Table 2: Nordic
Thingy:91 Operating modes and LED indications on page 14 to determine the present state of
Nordic Thingy:91.
5. Associate the Nordic Thingy:91 to your user account.
Enter the IMEI and PIN information that is found on the sticker on the Nordic Thingy:91 PCB. Wait for
blue breathing which means that your Nordic Thingy:91 is associated and connected.
Figure 6: Associating Nordic Thingy:91 to nRF Cloud
4418_1336 v1.2
10