Datasheet

Chassis Mount, Clamp Construction Page 2 of 6
Chassis Mount, Clamp Construction
230 or 115/230 VAC Primary transformer, 6VA - 200VA
Chassis mounting low voltage mains transformers designed according to the following specifications.
Specifications:
Power:
Frequency:
Primary:
Secondary:
Isolation:
Temp. class:
Approvals:
50 - 1000 VA
50/60 Hz
230 or 115/230 VAC
2 parallel (see list below)
4 kV RMS
A (105°)
BS3535 and EN 60 742
Chassis mounting low voltage mains transformers with a single 230 VAC or twin 115 VAC
50/60Hz primary winding. The two independent secondary windings may be connected in
series or parallel to give a wide range of output voltage and current options.
• Double section bobbin construction
• Fully shrouded bobbins
• Full varnish impregnation
• Two hole fixing wrap-over clamps
• Solder tag terminations
• Optional terminal shrouds
• 100% electrical and flash tested
Selection guide
rated regulation dimensions fixing centers wt.
VA % typ. L. W. H. kg
6 25 45 40 37 53.5x4BA 0.2
12 15 59 50 50 70x2BA 0.4
20 12 59 57 50 70x2BA 0.55
50 10 79 62 65 92x2BA 1.0
75 10 79 75 65 54x54x4BA 1.5
100 10 89 68 75 57x43.5x2BA 1.6
150 10 100 82 82 72x60xM5 2.0
200 7 100 92 82 72x70xM5 2.8