Installation Instructions

10
Feed the Axle through the holes in the Pivot Bracket which will allow the top edge of the plow to be
2” BACK FROM THE BOTTOM EDGE as shown in the above.
IMPORTANT: THE AXLE MUST BE 7“ UP FROM THE GROUND FOR PROPER PLOW OPERA-
TION. Secure the Axle with a cotter pin at the opposite end as shown.
For the (2) holes closest to the ATV: Use the
1/2” x 1’ long bolts, nylon insert lock nuts, with
washers positioned as shown, and secure from
underneath as shown. Do not tighten fully, but
allow parts to pivot freely.
AXLE
AAAA2”
PLOW BLADE SIDE VIEW
AAAA7”
PIVOT BRACKET
PIVOT PLATES
ATTACHED TO
PLOW
11
PAGE - 6