Installation Instructions

Loosely assemble these parts only by finger tightening nuts and 1” bolts. Place loosely

assembled parts on the belly plate as shown in step - 9a below.

Arrange parts so the axle holes are 7” above the ground.

AFTER THE CORRECT 7” HEIGHT HAS BEEN SET,

Attach the Belly U - Bracket / Boot Plate Assembly to the

Belly Plate as shown with (4) 1” long bolts and lock nuts,

and TIGHTEN ALL BOLTS AND NUTS FULLY.

BELLY PLATE

BOOT PLATE

AXLE HOLE

BELLY

U-BRACKET

BELLY U-BRACKET / BOOT PLATE

ASSEMBLY

AAAA7”

AXLE HOLE

PAGE - 5