User's Manual

37
8.7 Default factory settings of the Laser engine
DEFAULT PARAMETER SETTINGS OF RF650 LASER ENGINE
Parameter Parameter number Default setting
Linear Code Type Security
Levels
0x4E 1
UPC-A 0x01 Enable
UPC-E 0x02 Enable
UPC-E1 0x0C Disable
EAN-8 0x04 Enable
EAN-13 0x03 Enable
Bookland EAN 0x53 Disable
Decode UPC/EAN
Supplementals
0x10 Ignore
Decode UPC/EAN
Supplemental redundancy
0x50 7
Transmit UPC-A Check Digit 0x28 Enable
Transmit UPC-E Check Digit 0x29 Enable
Transmit UPC-E1 Check Digit 0x2A Enable
UPC-A Preamble 0x22 System Character
UPC-E Preamble 0x23 System Character
UPC-E1 Preamble 0x24 System Character
Convert UPC-E to A 0x25 Disable
Convert UPC-E1 to A 0x26 Disable
EAN-8 Zero Extend 0x27 Disable
Convert EAN-8 to EAN-13
Type
0xE0 Type is EAN-13
UPC/EAN Security Level 0x4D 0
UPC/EAN Coupon Code 0x55 Disable
USS-128 0x08 Enable
UCC/EAN-128 0x0E Enable
ISBT 128 0x54 Enable
Code 39 0x00 Enable
Trioptic Code 39 0x0D Disable
Convert Code 39 to Code 32 0x56 Disable
Code 32 Prefix 0xE7 Disable
Set Length(s) for Code 39 0x12 / 0x13 2-55
Code 39 Full Ascii Conversion 0x11 Disable
Code 93 0x09 Disable
Set Length(s) for Code 93 0x1A / 0x1B 4-55
Interleaved 2 of 5 0x06 Enable
Set Length(s) for I 2 of 5 0x16 / 0x17 14
Interleaved 2 of 5 Check Digit
0x31 Disable