User's Manual

ITEM SPECIFICATION

Scan repetition rate 39 (± 3) scans/sec (bi-directional)

Laser power 1.2mW nominal (Scanning Mode)

0.8mW nominal (Aim Mode)

Laser Class IEC Class 2 devices

Print contrast Minimum 25% absolute dark/light

reflectance measured at 650nm

Scan angle 53º (typical)

Ambient Light Immunity

• Sunlight

• Artificial light

10 000 ft. candles / 107.640 lux

450 ft. candles / 4.844 lux

Usable scan distance depends on the bar code size and pitch, quality of the bar code

print and ambient light conditions as well as the pitch and angle of the laser beam in

reference to the bar code surface. Further information available from Nordic ID upon

request.

The laser engine used in the RF650 is programmed during the manufacturing process

by defining certain operational parameters with default values. These values may be

changed by the user by first setting the unit into a special programming mode and

then by scanning special bar codes listed below.

User programmable parameters with detailed descriptions and the respective bar

codes are listed in the following chapters and the factory default values are listed in

the next section starting at next page.