User's Manual

CHAPTER FIVE - CONECTIVITY

Configuring WLAN Interface of SDC Supplicant

In the SCU utility, configuring the WLAN interface for the SDC Supplicant

forms a new profile. To end in the new profile may happen in two ways. Either you

give a name to profile, which creates a new profile, or the SCU guides you through

the WLAN configuration steps, which creates a new profile with a name of the

SSID that your access point broadcasts. The following two illustrations of the

WLAN configuration show both the above-mentioned approaches.

Note! Creating and configuring a new profile does not make the profile

active. The SCU utility does not put a new profile to use after its creation

and configuration, but you have to select the new profile in the field of the

‘Active Profile’ on the Main property page in the SCU. When the profile is

selected the active one, the SDC Supplicant operates according to the

profile rules.

Configuring the WLAN interface under the SCU

guidance requires that your AP broadcasts its SSID.

Before you begin, open the SCU utility (see the

section ‘Before Starting to Configure WLAN’ on page

62) and select the Main page, if not selected. Check

that the value ‘Default’ has selected in the Active Profile

field. If that is not the case, change the active profile to

‘Default’ (see the section ‘Changing Supplicant of

WLAN Connectivity’ on page 69). After that tap on the

‘Profile’ tab to open the Profile page.

To configure WLAN interface under the SCU guidance:

1. Tap on the ‘Scan’ button on the Profile page; the SCU opens its Scan

window. The Scan window shows the SSIDs being within range.

Configuring

WLAN Interface

under SCU

Guidance

Note! If you do not see the SSID that you may expect, tap

on the ‘Refresh’ button.