User's Manual

CHAPTER FOUR – DATA CAPTURE

Before you begin, open the ‘NID Scanner’ control panel applet (see the section

‘Control Panel’ on page 30).

To enable decoding of a particular bar code type:

1. Select the ‘Codes’ tab in the NID Scanner applet

2. Check the check box of the symbology list item by tapping the check box

with the stylus

3. Press the ‘ok’ key; the decoding of the bar code is enabled.

To disable decoding of a particular bar code type:

1. Select the ‘Codes’ tab in the NID Scanner applet

2. Uncheck the check box of the symbology list item by tapping the check

box with the stylus

3. Press the ‘ok’ key; the decoding of the bar code is disabled.

Be aware that you can check right after tapping the checkbox of the

symbology the result of the change by pressing the scan key. The applet

displays the ‘Scan’ page and the scanner starts reading. If you aim the

reader at a symbol tag of that particular symbology, you can see the result

on the ‘Scan’ page.

Configuring Specifics of Symbology

Before you begin, open the ‘NID Scanner’ control panel applet (see section

‘Control Panel’ on page 30).

To set optional features of the bar code type:

1. Select the ‘Codes’ tab in the NID Scanner applet

2. Double-tap the bar code list item; the options window of the bar code type

opens.

3. Set the options of your choice

4. Tap the ‘OK’ button to approve your settings

5. Press the ‘ok’ key; the selected options are in use.

Changing Aim/Triggering Mode

Before you begin, open the ‘NID Scanner’ control panel applet (see section

‘Control Panel’ on page 30).

To set Aim/Triggering mode:

1. Select the ‘Misc’ tab in the NID Scanner applet

2. Select the ‘Trigger Mode’ of your choice.