User's Manual

CHAPTER TWO – GETTING STARTED

2. GETTING STARTED

INSTALLING BATTERY

Open the battery cover

1. Loosen the bolt of the battery compartment cover

2. Open the cover on the bolt end by lifting and pulling it

Put the battery into its compartment

Before you begin, check that the electrical conductors of the

battery will press against their counterparts in the compartment

1. First place the bottom end of the battery by putting it against the rubber

supports in the compartment at the bottom end of the device

2. Press the conductor end of the battery to the compartment so that the

battery and the compartment conductors press against each other

Close the battery cover

1. Put two protruding

parts at the top of the

battery cover into their

hollows on the device

2. Settle the bolt end of

the cover into its place

and fasten the cover to

the device by tightening

the bolt of the battery

compartment cover

ABOUT LITHIUM-ION BATTERY

Note that the lithium-ion (Li-ion) rechargeable battery included in the box is not

fully charged. Before first-time use of the device the battery must be fully charged.

Note that it is strongly recommended to charge the Li-ion battery indoors at

20°C temperature, or at temperature near that (± 2°C), because continual charging

at high or low temperature may cause degradation of battery performance even

within specified allowable temperature range.

Step One

Step Two

Step Three