User's Manual

CHAPTER SIX- CONFIGURING AND ADMINISTERING
106
MANAGING TOUCH SCREEN
Adjusting Double-tapping Sensitivity of Touch
Screen
Before you begin, open the ‘Stylus’
control panel applet (see section ‘Control
Panel’ on page 30).
Be aware that double-tapping is
measured against the maximum time
between two screen-taps in succession. That
is, quicker successive tapping than the
longest period you adjust between
consecutive taps in the area of check pattern,
the system view as a double-tap but the
longer does not. In addition, the time between
successive tapping to be a double-tap is
limited to certain maximum value by the
system.
To adjust double-tapping sensitivity:
1. Select the ‘Double-Tap‘ page in the Stylus applet
2. Follow the instructions on the page to adjust and to check the double-
tapping sensitivity
3. Once you are satisfied with your adjustment, tap the ‘OK’ button on the
title bar
Disabling/Enabling Touch Screen
Be aware that after disabling the touch screen you cannot enable it any longer
by tapping a checkbox with the stylus. If you want to enable the touch screen again
you have the following choices:
 Using the keypad to uncheck the ‘Touch screen lock enable’ checkbox
 Cold-booting your device, assuming that you have not made the change
permanent
 Resetting your PL3000 to the factory defaults, if you have made the
disabled state permanent.
Before you begin, open the ‘NID Touch Screen’ control panel applet (see the
section ‘Control Panel’ on page 30).