User's Manual

LAN AND USB
CONNECTIVITY
1. Mini-B (Mini USB)
2. RJ-45 (LAN)
3. Power supply
USB INTERFACE
 Full-speed (12Mbit/s)
 Low-speed (1.5Mbit/s)
 USB socket for Mini-B (Mini USB) plug.
The cradle can be connected e.g. to PC by
means of the USB cable with the Mini-B
connector at the other end.
LAN INTERFACE
 Ethernet 10/100BASE-TX
 LAN socket for RJ-45 plug
The LAN and USB connections can be
used simultaneously. Both connections are
plug-and-play. Your Nordic ID Morphic
LAN interface is set on factory default
settings, and the LAN into which you have
plugged the cradle provides DHCP
service.
CARE AND
MAINTENANCE
Your Nordic ID Morphic contains delicate
electronic parts. Therefore it is vulnerable
to environmental factors such as dirt,
extreme temperatures, humidity and
mechanical stress. Treat your Nordic ID
Morphic with care. The following hints help
you to preserve your device’s functionality
and longevity.
CLEANING
 The device can be wiped clean with a
damp, non-abrasive, clean, lint-free
cloth.
 Do not use harsh chemicals, strong
detergents, or abrasive cleaners to
clean the device.
HANDLING
 Avoid dropping the Nordic ID Morphic,
or bumping it against other objects.
Hard impacts can damage the device.
Note that damages caused by careless
handling are not covered by the
warranty.
 The touch sensitive colour display, i.e.
the touch screen, is vulnerable to
mechanical stress. Do not use sharp
objects or excess force on the touch
screen.
 Avoid storing the Nordic ID Morphic in
dusty and dirty or extremely humid, cold
or hot conditions. Harsh environmental
factors can shorten the life of electronic
components, damage batteries and
warp or fracture plastics or other
mechanical parts.
 When the Nordic ID Morphic is moved
from a cold environment to a warm
environment, condensation may lead to
a short circuit inside the device. It is
advisable to allow the device to
acclimatise for several hours, after
being brought in from the cold, before
powering up.
 Try to keep your Nordic ID Morphic dry.
Wipe spilled liquids immediately with a
dry, non-abrasive, clean, lint-free cloth.
If moisture gets inside your Nordic ID
Morphic because of condensation or
spillage, open the battery cover and
remove the battery. You may power up
the device again once it has dried. Do
not open the device case. Opening the
case voids the warranty.
 Before using the device, the batteries
must be fully charged. Charging takes
approx. 8 hours.
 The surface of the touch screen is
vulnerable to damage. Do not use a
sharp object or press hard on the
surface with the stylus
CRADLE
The Nordic ID Morphic docking cradle
includes electronics for charging battery,
and for emitting and picking up USB and
Ethernet signals. Therefore the cradle is
vulnerable especially to high and low
temperatures, splashed liquids, and rough
treatment. The following hints help
preserving the docking cradle’s health and
longevity.
Do not use the power supply for any other
purposes than for charging the
rechargeable batteries on the Nordic ID
Morphic device or on the battery charger
slot of the cradle.
2.
3.
1.