User's Manual

FCC Compliance
Statement
This hand-held device complies with part
15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This
device may not cause harmful interference,
and (2) this device must accept any
interference received, including interference
that may cause undesired operation.
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user’s authority
to operate the hand-held equipment.
FCC Compliance Notice
NOTE: This equipment has been tested
and found to comply with the limits for a
Class B digital device, pursuant to part 15
of the FCC Rules. These limits are
designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates,
uses, and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in
a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be
determined by turning the equipment off
and on, the user is encouraged to try to
correct the interference by one or more of
the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the
equipment and receiver.
Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced
radio/TV technician for help.
IC Compliance Statement
This hand-held device complies with
Canadian radio regulation.
Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device
must accept any interference received,
including interference that may cause
undesired operation.
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user’s authority
to operate the hand-held equipment.
To prevent radio interference to the
licensed service, this device is intended to
be operated indoors and away from
windows to provide maximum shielding.
Equipment that is used outdoors is subject
to licensing.
RF exposure statement
This equipment complies with EU, FCC and
IC’s RF radiation exposure limits set forth
for an uncontrolled environment under the
following conditions:
1. This equipment should be installed and
operated such that a minimum separation
distance of 20cm is maintained between
the antenna and user’s/nearby person’s
body at all times.
2. This equipment must not be co-located
or operating in conjunction with any other
antenna or transmitter.
THE PICTURE SHOWS THE SAFE
WAY TO HANDLE THE DEVICE.
Radio modules
The device contains an approved radio
module.
This module is identified below.
Module: SDC-SSD30AG
FCC ID: TWG-SDCSSD30AG
IC ID: 6616A-SDCSSD30AG
ETL listed
ETL LISTED
123456
CONFORMS TO UL STD 60950-1
CERTIFIED TO CAN/CSA STD C22.2 NO.
60950-1