Replacement Part List

CCCCB

BBBBA

AAAAA

X 8

X 4

1” LONG

3” LONG

3/4” LONG

BBBBA

Slide Blade Sections together with Tabs all pointing in the SAME direction.

PLACE BLADE SECTIONS FACE DOWN

A - Feed 1” long bolts through 8 - fastening points. Attach washers and nuts,

then finger tighten only. Align Blade Sections if necessary.

Feed 3” long bolts through (2) holes in each End Cap and Blade Section.

Attach washers and nuts, tighten fully.

Position the Blade for front access. Screw 3/4” Phillips screws into

pilot holes at (4) places as shown on the Blade front surface.

USING THE INCLUDED SCREWDRIVER AND YOUR WRENCH:

A - Tighten fully all 1” long bolts and nuts at 8 - fastening points (A).

B - Slide an End Cap over each end of the Blade .

ARE ALL BOLTS YOU HAVE INSTALLED TIGHTENED? CLIPS

INSTALLED? CHECK BEFORE GOING TO THE NEXT STEP.

TAB

WASHERS

IMPORTANT!

TIGHTEN FULLY

IMPORTANT!

TIGHTEN FULLY

BLADE SECTIONS

BLADE

END CAP

“U”

CLIP

BLADE

VERY IMPORTANT: (4) “U” CLIPS MUST BE FULLY

PUSHED DOWN OVER ADJOINING BLADE SECTION

FLANGES AT THE LOCATIONS SHOWN. SPACE 6”

APART - CENTERED AS SHOWN.

V 0612