User's Manual

11. M EN US | 57
Range for Wheel, AT and PStick is: On (Default), Off
 PStick MIDI can also be turned On or Off from the Extern panel
section.
5 - PEDAL MIDI PANEL A/B
For each panel it can be determined whether to send data generated
by the control (expression), swell, volume and sustain pedals. If any of
these should not generate MIDI data, turn its setting to Off. Note that
the volume parameter refers to volume pedal data. This setting does not
affect the Volume option in the Extern panel section.
Range for Ctrl, Swell, Vol and Sust is: On (Default), Off
 Sustain pedal MIDI can also be turned On or Off from the Extern
Panel section.
M Volume pedal data is only sent if the swell pedal is set to function
as volume pedal, in the System menu. Note that both swell and
volume data may be sent if the control pedal is set to function as
both control and swell pedal, and the swell pedal is set to work as
volume pedal.
6 - SEND ON LOAD
This setting toggles if any settings for the Program Change (PC), Volume
(Vol) or user defined MIDI CC (UsrCC) messages in the Extern section
should be automatically transmitted when a program is selected, or not.
Range for PC, Vol and UsrCC is: Off (Default), On
7 - PROGRAM CHANGE SETTINGS PANEL A/B
A “complete” Program Change message consists of three parts: A Bank
Select MSB value, a Bank Select LSB value and a Program Change
value.
M The Nord Stage 3 can send the Program Change message au-
tomatically, when a program is loaded, if the PC “Send On Load”
setting is set to “On”.
BANK MSB
The Bank Select MSB (“Most Significant Byte”) Control Change
message may be necessary to define if addressing a unit with a large
number of internal banks. According to the MIDI standard it is defined as
CC# 0, and uses one byte of data for a total of 128 bank values.
Range: 0-127, Off (Default Off)
BANK LSB
The Bank Select LSB (“Least Significant Byte”) Control Change mes-
sage - defined as CC# 32 - uses one byte of data to address a total of
128 banks.
Range: 0-127, Off (Default Off)
PROGRAM NUMBER
The actual Program Change message consists of one byte of data for a
total of 128 program values.
Range: 0-127, Off (Default Off)
8 - CONTROL CHANGE SETTINGS A/B
CTRL (CONTROL)
The Control Change number should be defined according to the pa-
rameter on the external unit which should be addressed. Refer to the
documentation of the external unit to see which CC numbers apply for
which parameters.
Range: 0-119, Off (Default Off)
VALUE
Define this value according to the initial value which should be sent
when using the CC Send On Load feature.
Range: 0-127, Off (Default Off)
9 - VOLUME VALUE A/B
The Extern section can send MIDI Volume (CC#7) messages, allowing
you to control the level of an external device. The value defined in this
setting determines the initial value sent when using the Volume Send On
Load feature.
Range: 0-127 (Default 0)
10 - GLOBAL SOFT THRU
Incoming MIDI that matches the Global or Panel A/B channels can be
re-routed, going out on the Extern channel if the Extern section is active
in the current program. This setting determines if this re-routing should
apply or not.
Range: Off (Default), On
M The Device and Pedal MIDI settings (pages 4 and 5 in the Extern
menu) also apply to re-routed MIDI on the Extern channel.