User's Manual

6. PROGRAM | 25

PROGRAM

The PROGRAM section provides access to performance functions such

as recalling and storing programs, access to the Song and Live modes,

keyboard split functionality and more. This is also where menus contain-

ing System, Sound, MIDI and Extern settings are found. The menus and

their settings are covered in a separate chapter, starting on page 53.

M Note that the exact location of certain panel features may differ

depending on the manufacturing date of the instrument.

MORPH ASSIGN

The Morph is a very powerful tool,

which allows for controlling several

parameters at once using one control

“source”. A foot pedal can be used

to control the balance between a

piano and a synth sound, the wheel

to perform drawbar changes in a B3 sound, and increase the rate of a

selected effect by keyboard aftertouch – all at the same time.

The three MORPH ASSIGN buttons, WHEEL, A TOUCH, CTRLPED, repre-

sent the three available Morph Sources: the modulation wheel, keyboard

aftertouch, and control pedal.

A Morph is set up by holding down one of the Morph Assign buttons,

while at the same time moving a parameter control (for example a knob

or a drawbar) from the point where the morph should start to the point

where it should end. It is a good practice to have the control set to the

desired start position before pressing down the morph assign button.

The display will show the start and stop values as the morph is set up.

Multiple parameters can be adjusted while pressing down a Morph

Assign button, and additional morph destinations can be added after a

morph has been assigned.

The following parameters are available as Morph destinations:

Organ Piano Synth Effects

Level Level Level Effect 1 Rate

Drawbars LFO Rate Effect 1 Amt

Rotary speed Osc Ctrl Effect 2 Amt

LFO Amount Delay Tempo

Filter Freq Delay Feedback

Resonance Delay Mix

Arp Rate EQ Mid / Filter Freq

Drive

Reverb Dry/Wet

 Double-clicking a Morph Assign button activates morph assign

latch mode, allowing for assigning morphs without keeping that

button pressed down. Press EXIT to leave latch mode.

 Morphs can be copied from one control source to another. See

page 28 for details on how this is done.