Manual

SK 180E Manual for frequency inverters
56 Pre-series version BU 0180 GB-0914
Control connection details
Terminal/
Designation
Function
Data
Description / wiring suggestion
Parameter
44 24V
24V supply
24 V DC ± 25%
50 … 500mA (according
to load on the digital
output)
Supply voltage connection for the
module
-
40 GND /0V
GND
Reference potential
-
C5 DIN
Digital input
Current consumption with
30 V DC: 13 mA
24 V DC: 10 mA
15 V DC: 5.5 mA
Switching thresholds
ON: > approx. 8.5 V
OFF: < approx. 7.5 V
Digital input for DC brake switching
-
B5 DOUT
Digital output
15 … 30 V, 200 mA, SPS-
compatible according to
EN61131-2
Low: 0 V / <30 mA
No current through brake
High: 24V / >70mA
Current through brake
Reporting of current status of the
mechanical brake
-
Potential isolation
79 MB+
Brake control
Voltage:
Mains brake
230 V~ 205 V=
400 V~ 180 V=
460/480 V~ 205 V=
Current: max. 0.5 A
The module SK CU4-MBR
generates an output voltage on
Terminals MB+/MB- for control of
an electromechanical brake. This
depends on the supply voltage and
the connection of the supply cable
to the one-way (L1
E
) or bridge
rectification (L1
B
) of the module.
The assignment of the correct
brake coil voltage must be taken
into account in the selection.
(NOTE: this function is identical to
P434=1)
P107*,
P114*,
P505
80 MB-
Brake control
Potential isolation
L1
E
Mains connection
1st phase
Supply voltage L1:
380V … 480 V ± 10% AC,
max. 10 A
Mains connection for one-way
rectification.
-
L1
E
-
L1
B
Mains connection
1. Phase
Supply voltage L1:
200V … 240 V ± 10% AC,
max. 10 A
Mains connection for bridge
rectification.
-
L1
B
-
L2 / N
Mains connection
2. Phase
Connection of 2nd phase for mains
connection L1
E
or L1
B
.
-
L2 / N
-
* Recommended setting (P107/P114) for NORD brakes: BRE5, 10, 40: 0.02s / BRE 20, 60 : 0.03s