Manual

6 Parameterisation
BU 0180 GB-0914 Pre-series version 129
Parameter
Setting value / Description / Note
Device
Supervisor
Parameter
set
P709 [-01]
...
[-07]
Voltage analog input
(Voltage of analog input)
-100.0 ... 100.0 %
Displays the measured analog input value.
[-01] = Analog input 1, Function of analog input 1 integrated into the FI
[-02] = Analog input 2, Function of analog input 2 integrated into the FI
[-03] = Ext. Analog input 1, AIN1 of the first I/O extension (SK xU4-IOE)
[-04] = Ext. Analog input 2, AIN2 of the first I/O extension (SK xU4-IOE)
[-05] = Ext. A.in 1 2nd IOE, AIN1 of the second I/O extension (SK xU4-IOE)
[-06] = Ext. A.in 2 2nd IOE, AIN2 of the second I/O extension (SK xU4-IOE)
[-07] = Setpoint module
P710 [-01]
[-02]
Analog output voltage
(Analog output voltage)
0.0 ... 10.0 V
Displays the delivered value of analog output.
[-01] = First IOE, AOUT of the first I/O extension (SK xU4-IOE)
[-02] = Second IOE, AOUT of the second I/O extension (SK xU4-IOE)
P711
State of relays
(State of digital output)
00000 ... 11111 (bin)
or
00 ... FF (hex)
Indicates the actual status of the digital outputs of the frequency inverter.
Bit 0 = Digital output 1
Bit 1 = Digital output 2
Bit 2 = reserved
Bit 3 = reserved
Bit 4 = Digital output 1, IO extension 1
Bit 5 = Digital output 2, IO extension 1
Bit 6 = Digital output 1, IO extension 2
Bit 7 = Digital output 2, IO extension 2
Bits 7-4
Bits 3-0
Minimum value
0000
0
0000
0
Binary
hex
Maximum value
1111
F
0011
3
Binary
hex
SimpleBox: The binary bits are converted to a hexadecimal value and displayed.
ParameterBox: The bits are displayed with increasing values from right to left (binary).
P714
Operating time
(Operating time)
0.00 ... ___ h
This parameter shows the time for which the FI was connected to the mains and was ready for
operation.