User guide

- 6 -
Operating and assembly instructions spring-loaded brake FDW – ATEX
Inspection of brake:
 Measure the air gap. When the max. admissible air gap has been reached,
disassemble the brake and replace the rotor
 Evaluate the armature disk
 Control rotor/hub connection
 Control function of the PTC thermistor: Resistance (at 20°C) < 100 Ohm
Additional information:
 The necessary inspection / maintenance intervals must be individually established
and have to be calculated by the plant manufacturers.
 Disassemble the brake in the reverse order that is required for an assembly
(page 3).
Bahnhofstraße 68
31691 Helpsen
Phone: [phone] – 0
Fax: [phone]
E-mail: [e-mail]