Instruction Manual

4
3 Installation
3.1 Cable Installation
1. Securely mount the control module (E01) inside the sprayer cab.
2. Connect the CANbus interface cable (C40) to the 9-pin connector located under the tray
in the right rear of the cab.
3. Connect the 6 pin Deutsch plug on cable C40 to the end of the control module labelled
Display Bus (the end of the control module with only one Deutsch connector).
4. At the 8-way coupler (on the boom), remove one of the 6-pin plugs and insert the power
jumper (E21) in its place.
Figure 1: Cable Installation
Figure 2: 9-Pin Connector
Figure 3: Power Jumper Installation