Manual

7
4.2 Installation with 3-Way Coupler and Terminator Plug
1. Remove the terminator plug (E20) from the existing 3-way coupler installed at the outer
sensor.
2. Install the 3-way coupler (E10) at the inner sensor. Plug the terminator plug (E20) and the
sensor cable into the 3-way coupler.
3. Connect the CANbus cable (C06) between the 3-way couplers.
Only the components shown in black are included in this kit.
Figure 5: Electrical Installation: 3-Way Coupler and Terminator Plug