Spray Height Control System UC4+ Enhanced Stability Option Installation Manual Improving the competitiveness of Industry and Agriculture through Precision Measurement
Printed in Canada Copyright 2005-08 by NORAC Systems International Inc. Reorder P/N: 4468BC+INST Rev D (UC4+ Enhanced Stability Option) NOTICE NORAC Systems International Inc. reserves the right to improve products and their specifications without notice and without the requirement to update products sold previously. Every effort has been made to ensure the accuracy of the information contained in this manual. The technical information in this manual was reviewed at the time of approval for publication.
TABLE OF CONTENTS 1 INTRODUCTION ................................................................................................................................. 1 2 GENERAL SYSTEM DESCRIPTION .................................................................................................. 2 3 PARTS LISTS......................................................................................................................................... 4 4 INSTALLATION PROCEDURE ................................
1 INTRODUCTION Congratulations on your purchase of the NORAC UC4+ Spray Height Control System. This system is manufactured with top quality components and is engineered using the latest technology to provide operating features and reliability unmatched for years to come. When properly used the system can provide protection from sprayer boom damage, improve sprayer efficiency, and ensure chemicals are applied correctly.
2 GENERAL SYSTEM DESCRIPTION Figure 1 depicts the general system layout of the UC4+ Spray Height Control system. Figure 1: System Components and General Location NOTICE: Every effort has been made to ensure the accuracy of the information contained in this manual. All parts supplied are selected specially to fit the sprayer to facilitate a complete installation. However, NORAC cannot guarantee all parts fit as intended due to the variations of the sprayer by the manufacturer.
3 PARTS LISTS The parts that come with your UC4+ Spray Height Control System are listed in Table 1. The item number on the left side of this table references each part. Please ensure that all parts in your kit are present before proceeding with your installation. Table 1: Enhanced Stability Boom Control System Parts Item Part Number Name Quantity B01 100091 TIE CABLE 7.
4 INSTALLATION PROCEDURE 4.1 ROLL SENSOR INSTALLATION Mount the roll sensor (E01) to the included roll sensor bracket using the machine screws and nylon lock nuts, as illustrated in Figure 2. The roll sensors must be mounted tightly to the brackets. d) The roll sensors must be mounted with the circular AMP connector facing towards the Right-Hand Wing (when looking from the rear of the sprayer). The reference frame (chassis) roll sensor must be the highest serial number. 1.
4.2 CABLE INSTALLATION 1. At the rear of the sprayer, near the NORAC valve block should be a cable with 6 connectors. 3. Route the long part of cable C01 towards the chassis roll sensor and connect it. 2. Locate the round AMP connector and insert cable C01 between the two connectors (Figure 4). 4. Cable tie the cables to existing wires and hoses. Be sure the cables will not be stretched or rubbed by any moving parts.
4.3 COMPLETING THE INSTALLATION 1. Start up your sprayer and test the sprayer’s functionality. The NORAC Control Panel does not need to be powered up for the original switches to function. Unfold the booms and raise/lower each boom and main section. Again confirm that the cabling/hoses are agreeable to the entire range of motion. 2. If any functions do not work, review the hydraulic and electrical portions of this manual to check for proper installation.
5 ELECTRICAL REFERENCE – CABLE DRAWINGS 5.
www.norac.ca Canada NORAC Systems International Inc. CALL TOLL FREE: 1-800-667-3921 (306)664-6711 SHIPPING ADDRESS: 3702 Kinnear Place Saskatoon, SK S7P 0A6 United States NORAC, Inc.
