Instruction Manual

8
8
Visit our Web Site www.n-c.com
Lubrication
The bearings are lubricated with Nor-Cal GHT high temperature lubricant. The user may need to add more lubricant from time to time, depending on the
frequency and temperature of bakeouts and operating environment.
The seals have a temperature limit of 150° C. (See “BAKEOUT” section). This lubricant has a temperature limit of 200° C.
************** WARNING *************
This lubricant has been tested to 230° C. We recommend limiting the temperature of the lubricant to 200° C or less.
The manufacturer warning states “....avoid inhalation of decomposition products formed above 300° C.” We believe this material may give off toxic
gasses at elevated temperatures.
Do not run uncontrolled bake-outs
Motorized operation
This platform can be motorized. Retrofit kits are available for field installation. Please consult the factory for further information.
All motors and limit switches/ position indicators must be removed during bakeout.
PARTS AND FACTORY SERVICE
Replacement parts and non-warranty factory service are available on a fast turnaround basis. Please consult the factory with your specific
need. Following is a list of replacement parts and current services available.
SEAL SETS
Part # For
RSSS-150 Set of Three seals for RS-150
RSSS-250 Set of Three seals for RS-250
RSSS-400 Set of Three seals for RS-400
RSSS-600 Set of Three seals for RS-600
RSSS-800 Set of Three seals for RS-800
FINE ADJUST KITS
Part # For
RSFA 150 RS-150
RSFA 250 RS-250
RSFA 400 RS-400
RSFA 600 RS-600
RSFA 800 RS-800