User guide
Table Of Contents
- Product Identification
- Validity
- Intended Use
- Functional Principle
- Trademark
- Patents
- Scope of Delivery
- 1 Safety
- 2 Technical Data
- 3 Installation
- 4 Operation
- 5 Deinstallation
- 6 Maintenance, Repair
- 7 Returning the Product
- 8 Disposal
- Further Information
- ETL Certification
- Declaration of Contamination
- EC Declaration of Conformity
22 CDG100-OP-LIT (2010-1)
4 Operation
Put the gauge into operation. If you are using a Nor-Cal con-
troller, define the measurement range.
A warm-up time of at least 90 minutes should be allowed; for
precise pressure measurements a warm-up time of at least
3 hours is required.
4.1 Status Indication
SP1
SP2
STATUS SP ZERO
LED
LED status
Meaning
<STATUS>
off
no supply voltage
lit solid green measurement mode
blinking green
short blinks
long blinks
warning
warming up
lit solid red
error
<SP1>
lit solid green
p
≤
setpoint 1
blinking green
waiting for setpoint 1 input
off
p > setpoint 1
<SP2> lit solid green
p
≤
setpoint 2
blinking green
waiting for setpoint 2 input
off
p > setpoint 2