User guide
Table Of Contents
- Product Identification
- Validity
- Intended Use
- Functional Principle
- Trademark
- Patents
- Scope of Delivery
- 1 Safety
- 2 Technical Data
- 3 Installation
- 4 Operation
- 5 Deinstallation
- 6 Maintenance, Repair
- 7 Returning the Product
- 8 Disposal
- Further Information
- ETL Certification
- Declaration of Contamination
- EC Declaration of Conformity
CDG100-OP-LIT (2010-1) 17
Mount the gauge so that no vibrations occur. The gauge
may be mounted in any orientation. To keep conden-
sates and particles from getting into the measuring
chamber preferably choose a horizontal to upright posi-
tion. If adjustment should be possible after the gauge
has been installed, be sure to install it so that the but-
tons can be accessed with a pin (→ 23).
Remove the protective lid and connect the product to the
vacuum system.
Seal with centering ring
Protective lid
Clamp
Keep the protective lid.