User Guide

ManualsBrandsNONSTOP ManualsAudio EquipmentBluetooth Wireless Speaker QI Fast Charging Pad

Setup &

Usage Guide

Station

Qi Certified Fast Wireless charging

Summary of content (10 pages)

PAGE 1
Station Setup & Usage Guide Qi Certified Fast Wireless charging
PAGE 2
Interface & Display 1 Qi charging area 2 USB CHARGING PORT (1A) 3 USB CHARGING PORT (2.
PAGE 3
Back Panel & Ports 20 Port cover latch 21 Line in cord pass through 22 Power cord pass through 23 Security screws 24 Aux In Audio port 25 DC Power port 26 Time Set button 27 Hour Quick Adjust button Specifications Port Cover Closed 21 22 20 23 Port Cover Open 24 25 TIME SET HR ADJ 26 27 Power .............................................................................................................. DC 9V 4.0A Adapter AC Power Supply ...........................................
PAGE 4
Installation Full Date & Time Set Open the Port Cover and insert the small end of the AC/DC adapter into the DC Power port located on the back of the Station A. Connect the other end to a wall outlet (110V AC). 1. On the back of Station A, press and hold TIME SET button, the hour digits will flash. Press HOUR button to set the hours. (You can tap or hold down to change the time faster). As you cycle through, the hours will change from AM to PM. If desired, connect the Aux In Audio cord into the port.
PAGE 5
Setting the Alarm Qi wireless charging To set the time, press the HR button and MIN button to change the alarm time. Place your wireless device on top of the Station A. Charging will begin on contact. When wirelessly charging, the Qi charging indicator will flash slowly. Press the ALARM button to turn "ON". When the alarm is on, the icon will appear the display. Using the Alarm To snooze, tap the SNOOZE button on the top. The Alarm will sounds again after 10 minutes.
PAGE 6
Listening with Bluetooth Listening with Aux In Audio 1. With the Station A plugged in, press the BLUETOOTH button to turn on the speaker in Bluetooth mode. The Bluetooth icon will appear on the display and flash. 1. To listen to music from an external audio device (e.g. iPhone, iPad, iPod shufﬂe, mobile phone, MP3 player, digital media player, etc.) plug the aux in 3.5mm audio cable in the the headphone port on your device. 2.
PAGE 7
SAFETY PRECAUTIONS Some of the following information may not apply to your particular product; however, as with any electronic product, precautions should be observed during handling and usvve. 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do not block any of the ventilation openings. Install in accordance with the manufacturer’s instructions. 8.
PAGE 8
FCC STATEMENTS NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant toPart 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
PAGE 9
CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. DANGEROUS VOLTAGE: The lightning flash with arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninsulated dangerous voltage within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.