Product Manual

nVISION Software

7. Click OK.

8. For more information, see nVISION Help.

Figure 16: nVISION Settings Window

Cable Connection

NOTE: To save battery life, the Model 3150 will automatically shut off after 60 minutes

when it is connected to a PC using the USB interface cable.

To connect the device to a PC, use the PC USB interface cable found in the starter kit. Once

connected to a PC, the device settings may be accessed and data can be downloaded using

nVISION software.

The USB driver software for the cable needs to be installed before the device can connect to

the PC. The software is located in the USB Driver folder on the Operator’s Manual CD.

1. Install USB driver if needed. See appropriate “USB Driver Installation” section for more

information.

2. Connect the cable to the USB port on the PC.

3. Connect the cable to the device’s sensor port.

4. When the device is ready to use with nVISION, these indicators display on the LCD:

• CP

• Battery indicator