Instructions / Assembly

ManualsBrandsNone ManualsOtherSVE-3

SERIES III

FLEXMASTER CANADA LTD Z-FLEX US, INC

452 ATTWELL DRIVE 20 COMMERCE PARK NORTH

ETOBICOKE, ONTARIO BEDFORD, NH

M9W 5C3 03110-6911

UNDERWRITERS LABORATORIES, INC.

UL 1738 & BH636

INSTALLATION AND MAINTENANCE

Designed for Hamilton WGH Garage Heaters Being Installed

Distributed Exclusivel

Hamilton Home Products, Inc.

Category III

In Downward Sloping Side Wall Venting Applications Only

MODEL SVE

INSTRUCTIONS

TESTED AND LISTED BY

Hamilton SVE-3 Horizontal Stainless Steel Ventin

stem

Summary of content (6 pages)

PAGE 1
MODEL SVE SERIES III INSTALLATION AND MAINTENANCE INSTRUCTIONS Hamilton SVE-3 Horizontal Stainless Steel Venting System Distributed Exclusively By Hamilton Home Products, Inc. Designed for Hamilton WGH Garage Heaters Being Installed In Downward Sloping Side Wall Venting Applications Only Category III TESTED AND LISTED BY UNDERWRITERS LABORATORIES, INC.
PAGE 2
SPECIAL STAINLESS STEEL VENTING For use with Category II, III, IV appliances Contact Local Building or Fire Officials about Restriction and Installation Inspections in you area as well as National Codes: USA - National fuel gas code ANSI-Z223.1 CANADA - CAN/CGA-B149.1 or .
PAGE 3
KIT CONTENTS Inspect the kit to verify the following parts are present before proceeding with the installation. Contact Hamilton at 1-800-879-0123 if a part is missing. Read the instructions completely before installing. 3' Vent Pipe 12" Appliance Screened Vent Termination Tee Vent Adapter 3" Gear Clamp Adjustable 3" Gear Clamp Wall Thimble JOINT PROCEDURE The female end of each Z-Vent III component incorporates a silicone sealing gasket (except for 12" Appliance Vent Adapter).
PAGE 4
INSTALLATION FOR: Downward Sloping Side Wall Venting Applications Only (Refer to Illustration on Page 5) 1. Penetrating a combustible wall requires the use of a Wall Thimble. (If the wall is non-combustible, the Vent pipe may be mortared in directly without using a wall thimble.) Install Wall Thimble into wall, observing the aforementioned rules and/or local building codes. Select the point of wall penetration where a minimum 1/4" per foot of slope (6.4mm per 305mm) can be maintained.
PAGE 5
Hamilton SVE-3 Horizontal Stainless Steel Vent Kit Assembly (For Downward Sloping Side Wall Venting Applications Only) Adjustable Wall Thimble Locking Band Gear Clamp 12" Appliance Vent Adapter 3' Vent Pipe Bead of Silicone on Vent Connector Locking Band Screened Vent Termination Tee Note : Vent must terminate a minimum of 12" above the ground or normally expected snow accumulation level.
PAGE 6
Z-FlexTM LIMITED LIFETIME WARRANTY Z-FlexTM ("Seller") extends the following LIMITED WARRANTY for Z-VENT (the "Z-VENT"): Seller Warrants that at the time of purchase, the Z-Vent will be free of manufacturer's defects in material and/or workmanship. This warranty shall extend to the original purchaser of the Z-Vent or, if purchased by a contractor, to the end user.