Instructions / Assembly

030099-177 Rev B Page 2 of 2

i. Complete plumbing to fountain. Check for leaks on new plumbing installations, run water

through the bubbler(s) until water taste satisfactory.

j. On electronic eye models, place and then hold hand approximately 3" (76 mm) from the

sensor to actuate the solenoid valve. After approximately 30 seconds run time, the

sensor will automatically shut off the solenoid valve. To reactivate, move hand away for

an instant and then again place it in front of the sensor. Repeat until the stream from the

bubbler is free of bubbles.

TO ADJUST THE BEAM RANGE OF THE SENSOR

a. Shut off the water and power supply. Remove the rear bottom plate.

b. Unscrew the sensor bracket screws from the front mounting plate and remove the sensor

unit and bracket sufficiently to gain access to the bracket front face. Remove the foam

strip between the two lenses in order to uncover the sensor adjusting screw.

c. The screw can be turned a maximum of 3/4 turns. Turn screw counterclockwise to

decrease range. The sensor has an adjustable range of 24" (610 mm) to 48" (1219 mm).

It is factory set at 27" (686 mm). There is a non-adjustable on-time delay of 1.5 seconds

to prevent nuisance actuation of the solenoid valve should someone walk by. After

draining, the water will shut off immediately after walking away. Maximum run time is 30

seconds.

d. NOTE: Walls with a reflective finish, i.e., ceramic tile, across from the sensor may cause

false actuation no matter what the sensor adjustment is for distance. Therefore, do not

install the unit in such an area or dull the surface of the wall so it will not reflect light. The

bubbler valve will not actuate if objects cover over the electronic eye lens, i.e., necktie or

hand.

WARNING

The warranty and the Underwriters' Laboratory listing for this machine are automatically voided if

this machine is altered, modified, or combined with any other machine or device. Alteration or

modification of this machine may cause serious flooding and/or hazardous electrical shock or

fire.

XCEPT AS SET FORTH HEREIN

THE MANUFACTURER MAKES NO OTHER WARRANTY

GUARANTEE OR

AGREEMENT EXPRESSED

IMPLIED OR STATUTORY

INCLUDING ANY IMPLIED WARRANTY OR

MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE

OASIS

is a registered trademark of OASIS Corporation

“Three Palms Design” is a registered trademark of OASIS Corporation