User's Manual

Hempasense Track Version 1.5
Page | 6
cured, then shake the sensor to indicate the job is done. Turn the sensor upside down to
put it into sleep mode. The sensor can now be assigned to a new job.
After each shake, the LED on the bottom of the sensor either blinks green or red to indi-
cate whether the shake was accepted or not. It is always possible to see the current job
status in the mobile app and web app. Use this feature to ensure the shakes have been
recorded properly.
LED light guide
The LED light can be seen on the bottom of the sensor. The colour of the light and the
blinking sequence indicates different stages of the sensor:
Single blue flash – sensor is turned upside down and is in ‘pre-sleep’ mode.
90sec. countdown has started until sleep.
Double short blue blink – 90 sec. countdown expires and sensor goes in sleep
mode. Use the sleep mode when the sensor is not assigned to any job to save
battery.
Fast blinking blue/green for 1 sec. – device is turned upright and wakes from
sleep mode. Remember to wake up the sensor assigned for the specific job,
prior coating.
3 slow green blinks – device accepts shake to indicate start of next phase.
x1
x2