User's Manual

Hempasense Track Version 1.5
Page | 5
Hardware
Parameters
1. ATEX certified sensor
2. Measures:
a. Ambient temperature
b. Relative humidity
c. Vibrations (accelerometer)
Functionalities
1. Turn sleep mode on and off
2. Shake sensor to register start of process
3. LED light guide
Turn sleep mode on and off
To put the sensor in sleep mode, turn it upside
down and wait for blue light flashes one LED
To wake up the sensor from sleep mode, turn it
right side up and wait for blue fast flashes on
LED. Sensor should only be put into sleep mode
when it is not being used on a job.
Shake – record process starts
Between the steps in the process of applying coatings, shake the sensor 3 times to record
progressing from one step to the next.
More specific, when you start applying the first layer of coat-
ing, shake the sensor. When the first layer of coating is ap-
plied and the drying/curing phase starts, shake the sensor. If
the job includes more than one coat, shake the sensor when
the second layer of coating is about to be applied. When the
second layer is applied and the drying/curing phase starts,
shake the sensor. Continue this process throughout the job
until the last drying phase is done and the last coat has