DX5.0 Installation & User Manual Version 2.
Manufacturer Humotion GmbH Heerdestraße 23 D – 48149 Münster Germany www.humotion.net Model Number SmarTracks Diagnostics Version Smart Run Version Manual Version FCC ID DX5.0 v.3.17 v.3.5.9 v.2.
Made in Germany Content 1. DX5.0 General Information and Specifications ............................................................................... 3 2. Safety Instructions ........................................................................................................................... 5 3. Information on Disposal and Recycling ........................................................................................... 5 4. Installation of SmarTracks Diagnostics ........................
1. DX5.0 General Information and Specifications The DX5.0 is a movement monitoring device about the size of a Flash drive. It is capable of recording a vast range of data. The recorded data can be easily exported into a useable format for independent analysis. Control of and interaction with the DX5.0 (data recording, data transfer, battery charging) is enabled through usage of the SmarTracks Diagnostics software as well as the through the Smart Run mobile application.
Housing ▪ ▪ 3D printing ABS housing Water resistant IP44 SmarTracks Diagnostics ▪ ▪ ▪ Version: v.3.17 Required Disk space: 23 MB System requirements: Operating system: Windows 10 32bit / 64bit or higher Microsoft .NET Framework v4.5 or higher Smart Run ▪ ▪ Version: v.3.5.9 Mobile device requirements: iOS 8.0 or newer Minimum Android 5, recommended Android 7.
2. Safety Instructions Non-compliance with this safety information may lead to fire, electric shocks or other injuries, or may lead to damage of system components. Do not drop the DX5.0 and do not dismantle, open, break, bend, deform, drill through, crush, burn or paint it. Do not heat in a microwave and do not insert foreign objects into the device. When connecting the DX5.0 to your computer, we recommend using the supplied USB cable to protect your computer from humidity and dirt.
4. Installation of SmarTracks Diagnostics The Humotion SmarTracks Diagnostics software is either supplied on an USB stick, or you will be given access details for the Humotion download server. Its intended use is on a PC with a Microsoft Windows operating system Windows 8.1 or Windows 10. To install SmarTracks Diagnostics when the software is supplied on a USB stick: 1. 2. 3. Connect the supplied USB stick. Open the “SetupSmarTracks.msi” file. Select “Next” and follow the rest of the instructions.
Data Transfer Each time a measurement is stopped by connecting the Humotion DX5.0 with your computer’s USB port recorded data is transferred automatically to your computer. Progress of current data transfer is shown in the SmarTracks Diagnostics software. NOTE: Do not unplug the USB cable from the Humotion DX5.0 before data has been transferred completely. Unplugging during an active data transfer may lead to permanent loss of recorded data on the Humotion DX5.0. 5.2.
5.3. Battery Charging The Humotion DX5.0 can be charged with any USB port with a minimum output of 500 mA (nominal voltage of 5V). Each time the Humotion DX5.0 is connected with your computer’s USB port (e. g. to start or stop a measurement) the battery of the Humotion DX5.0 is charged automatically as required. NOTE: To charge the Humotion DX5.0 always use the supplied USB cable. 6. Regulatory Notices 6.1.
